注塑模具文献
⑴ 求 注塑模具 英文文献资料
模具述语
一、入水：gate
进入位：gate location
水口形式：gate type
大水口：edge gate
细水口： pin-point gate
水口大小：gate size
转水口：switching runner/gate
唧嘴口径：sprue diameter
二、流道: runner
热流道：hot runner,hot manifold
热嘴冷流道: hot sprue/cold runner
唧嘴直流: direct sprue gate
圆形流道：round(full/half runner
流道电脑分析：mold flow analysis
流道平衡:runner balance
热嘴：hot sprue
热流道板：hot manifold
发热管：cartridge heater
探针: thermocouples
插头：connector plug
插座： connector socket
密封/封料： seal
三、运水：water line
喉塞：line lpug
喉管：tube
塑胶管：plastic tube
快速接头：jiffy quick connector plug/socker
http://www.3359088.com 或者 http://www.0086k.com
⑵ 注塑模具设计英语文献 谁可以提供一份啊
⑶ 注塑模具的英文文献大哥你有吗英文要求为完整资料，出处，年卷期作者等完整
DESIGN OPTIMIZATION OF AN INJECTION MOLD
FOR MINIMIZING TEMPERATURE DEVIATION
International Journal of Automotive Technology , Vol. 13, No. 2, pp. 273−277 (2012)
⑷ 注塑模具外文文献 谁可以提供一份啊
求给一份啊，[email protected]
⑸ 求一份关于注塑模设计的外文文献和翻译，感激不尽~~
Rapid prototyping technology advent of time is not long, but because it brings huge profits of manufacturing makes this techniques are applied widely, especially to die design and manufacture brought a leap. Rapid prototyping technology can precisely manufacture the mold cavity, the XingXin and also can be applied directly to injection process procing plastic samples, so as to identify and correct the mistakes. Because of the rapid prototyping manufacturing this new technology of application, make die design and manufacture graally tends to digital, quickly, making mould manufacturing in short cycle, lower the cost of process, greatly step forward.
According to mould material, the proction cost, RP, the prototype of materials, proction batch, mould accuracy requirement has developed a variety of technological process.
This time这里文字有限