注塑模具文獻
⑴ 求 注塑模具 英文文獻資料
模具述語
一、入水：gate
進入位：gate location
水口形式：gate type
大水口：edge gate
細水口： pin-point gate
水口大小：gate size
轉水口：switching runner/gate
唧嘴口徑：sprue diameter
二、流道: runner
熱流道：hot runner,hot manifold
熱嘴冷流道: hot sprue/cold runner
唧嘴直流: direct sprue gate
圓形流道：round(full/half runner
流道電腦分析：mold flow analysis
流道平衡:runner balance
熱嘴：hot sprue
熱流道板：hot manifold
發熱管：cartridge heater
探針: thermocouples
插頭：connector plug
插座： connector socket
密封/封料： seal
三、運水：water line
喉塞：line lpug
喉管：tube
塑膠管：plastic tube
快速接頭：jiffy quick connector plug/socker
http://www.3359088.com 或者 http://www.0086k.com
⑵ 注塑模具設計英語文獻 誰可以提供一份啊
⑶ 注塑模具的英文文獻大哥你有嗎英文要求為完整資料，出處，年卷期作者等完整
DESIGN OPTIMIZATION OF AN INJECTION MOLD
FOR MINIMIZING TEMPERATURE DEVIATION
International Journal of Automotive Technology , Vol. 13, No. 2, pp. 273−277 (2012)
⑷ 注塑模具外文文獻 誰可以提供一份啊
求給一份啊，[email protected]
⑸ 求一份關於注塑模設計的外文文獻和翻譯，感激不盡~~
Rapid prototyping technology advent of time is not long, but because it brings huge profits of manufacturing makes this techniques are applied widely, especially to die design and manufacture brought a leap. Rapid prototyping technology can precisely manufacture the mold cavity, the XingXin and also can be applied directly to injection process procing plastic samples, so as to identify and correct the mistakes. Because of the rapid prototyping manufacturing this new technology of application, make die design and manufacture graally tends to digital, quickly, making mould manufacturing in short cycle, lower the cost of process, greatly step forward.
According to mould material, the proction cost, RP, the prototype of materials, proction batch, mould accuracy requirement has developed a variety of technological process.
This time這里文字有限